Security & Life Integrations Inc

Carbon Monoxide Detector Installation in Raleigh, NC

A Wake County daycare got a letter from its licensing consultant last spring: the classrooms sat above a parking level and the building had no carbon monoxide detection tied to the fire alarm. The owner's first call was to an electrician, who sent her to us. Commercial CO detection in Raleigh is a fire alarm job more often than a hardware-store job, because the code wants the detectors supervised, monitored and tested, and that means a permit, a panel and an acceptance test. We install and monitor it across Raleigh and the Triangle from our Glenwood Avenue office.

Get Raleigh CO Detection Pricing

Which Raleigh Buildings the Code Reaches

North Carolina's fire and building codes follow the international model code language on carbon monoxide, which ties the requirement to two things: people sleeping or being cared for in the building, and a source of CO. The source is a fuel-burning appliance, a fireplace, or an attached or underneath parking garage. When both are present, new construction and most changes of use in Raleigh need CO detection in the sleeping units, classrooms or care areas, or in the corridors and mechanical rooms that serve them. Hotels and motels have a separate state rule, passed after the Boone deaths in 2013, that reaches existing lodging rooms near fuel-burning equipment regardless of the building's age.

For an existing office or retail building with a gas rooftop unit and nobody sleeping inside, the code usually does not require detection, and we say so. For a hotel, an assisted living building, a daycare, a school or an apartment community with gas appliances or a garage, it usually does, and the fire marshal's office will ask about it at the next inspection or the next permit. The statewide picture is on our commercial carbon monoxide detection page; what code requires for commercial CO detection goes through the occupancy list in detail.

Plug-In Alarm or System Detector?

The question we answer most often in Raleigh is whether the building can use the listed 120-volt CO alarms sold at any hardware store. Sometimes. Where the code accepts them, they are the cheapest route at $120 to $200 each installed, interconnected so that one sounding sets off the others. What they cannot do is report. Nobody at a monitoring station knows one went off at 3 a.m. in an empty school, and the fire marshal has no record that it was tested. For buildings with an existing fire alarm panel, the better answer is almost always an addressable CO detector on the panel: supervised wiring, a signal to the central station, and a line on the annual inspection report. Where the layout allows it, a combination smoke and CO detector covers both with one device.

  • System-connected detectors: Addressable CO or combination smoke/CO detectors on the existing fire alarm panel. Supervised, monitored, tested annually with the rest of the system.

  • Listed 120-volt alarms: Interconnected plug-in or hardwired CO alarms where code accepts them. No monitoring, no supervision, ten-year replacement.

  • Garage ventilation sensors: CO sensors wired to the garage exhaust fans in parking decks and loading docks, priced per sensor and fan zone.

  • Monitoring: CO signals ride the same communicator as the fire alarm. On most accounts there is no added monthly cost.

What CO Detector Installation Costs in Raleigh

Adding addressable CO detectors to an existing fire alarm panel typically runs $250 to $450 per detector installed, including programming and the acceptance test, with a project minimum of around $1,500 for permit and testing time. Combination smoke and CO detectors run $300 to $500 each and save a device where the layout allows. Listed 120-volt interconnected alarms are $120 to $200 each installed where code accepts them. A garage ventilation sensor system is priced per sensor and per fan zone and usually lands in the low thousands for a single-level deck. If the building's panel is full or too old to take new addressable points, that changes the number, and we tell you on the site walk rather than on the invoice.

A forty-room hotel near Crabtree Valley with gas water heaters and a gas laundry, for example, usually needs detection in the mechanical rooms and the rooms and corridors adjacent to them rather than in every guest room, which keeps the device count and the cost down. What the monthly monitoring fee buys explains how the CO signal is handled once it reaches the station.

Permit, Install, Acceptance Test

Inside Raleigh city limits a fire alarm modification goes through the city's development services and the fire marshal's office; in Cary, Apex, Wake Forest and unincorporated Wake County the town or county handles it. Adding CO detectors to a fire alarm panel counts as a modification. We prepare the submittal, pull the permit, install and program the devices, and schedule the acceptance test with the inspector. Testing a CO detector means exposing it to test gas and confirming the panel and the monitoring station both see it, which is not something a general electrician is set up to do. The whole thing is usually two to four weeks from signed quote to passed test for a typical building, most of that waiting on review.

If the building has no fire alarm system at all and the code requires monitored CO detection, that is a fire alarm installation conversation, and the CO detectors become part of the new system's device count. General contractors handling a change of use, an office becoming a daycare for example, can bring us in as the fire alarm sub; the GC subcontracting page explains how we price from drawings.

The Raleigh Buildings That Need It Most

Our CO work in the Triangle concentrates in a few property types:

After the Install

CO detectors on a fire alarm system get tested at the annual inspection along with everything else, and system detectors have an end-of-life date, typically five to ten years depending on the sensor, after which the panel reports them as trouble. Both land on the annual fire alarm inspection report. If a detector fails or the panel starts reporting a CO trouble, our Raleigh fire alarm repair team handles it. Sprinklered buildings get the sprinkler and the fire alarm inspected on the same visit through our Raleigh fire alarm and sprinkler services. The inspection schedule by state is in fire alarm inspection requirements in NC, SC and GA.

We cover Raleigh, Cary, Durham and Chapel Hill from the same office. Our fire alarm work is led by a NICET Level III technician under North Carolina license SP.FA/LV.36697.

Raleigh Carbon Monoxide Detection Questions

Does my Raleigh office building need CO detectors?

Usually not, if nobody sleeps or receives care in it. The code reaches residential, lodging, institutional and classroom occupancies with a fuel-burning appliance or an attached garage. An office with a gas rooftop unit is normally exempt. If you are converting part of it to a daycare or clinic, that changes.

Can an electrician just install plug-in CO alarms?

Where code accepts listed 120-volt alarms, yes, and they are the cheapest route. In buildings with a fire alarm system the fire marshal generally expects the detection to be on the panel, monitored and tested, which is fire alarm work and needs a permit.

How many detectors will a hotel need?

Fewer than most owners expect. Detection goes in the rooms and corridors adjacent to fuel-burning equipment and in the mechanical rooms themselves, not in every guest room. A site walk settles the count; typical cost is $250 to $450 per detector on an existing panel.

Is CO monitoring an extra monthly fee?

On most accounts, no. CO signals travel on the same communicator as the fire alarm and are handled by the same central station. See fire alarm monitoring for how signals are dispatched.

How long does the project take?

Two to four weeks for a typical Raleigh building, most of it waiting on plan review. The install itself is usually a day or two, scheduled around guests, students or residents.

Our Certifications & Associations

NC State Board of Examiners of Electrical Contractors seal

SP-FA/LV License #36697

NC Board of Examiners of Electrical Contractors

North Carolina Department of Public Safety logo

NC Alarm Business License

NC Alarm Systems Licensing Board

North Carolina Department of Public Safety logo

Registered Alarm Technicians

NC Alarm Systems Licensing Board

South Carolina Law Enforcement Division seal

SLED Alarm Contractor License

South Carolina Law Enforcement Division

South Carolina Department of Labor, Licensing and Regulation logo

Burglar Alarm Contractor

SC Dept. of Labor, Licensing & Regulation

South Carolina Department of Labor, Licensing and Regulation logo

Fire Alarm Contractor

SC Dept. of Labor, Licensing & Regulation

NICET logo

NICET Level III

Fire Alarm Systems

$2M General Liability

Fully Insured

Brivo logo

Brivo

Manufacturer Certified

ButterflyMX logo

ButterflyMX

Manufacturer Certified

Bosch logo

Bosch Security Systems

Manufacturer Certified

Loved by Thousands of Organizations

Kesha Coley

I knew when I called and had a conversation with Donna that they would be a good fit to do business with. Donna and Zach was very friendly and responsive. I was switching from a different company and im so glad that I did. Zach came and installed a new security system for my business and was able to switch over my fire panel to meet county standards to stay in compliance. Zach was also able to switch my camera system to monitor. The transition process was smooth. Thank yall for helping us out at Brighter Minds Academy 2

Gianna

Zach with Security & Life Integrations did an awesome job with helping our new clinic set up the cameras and key fobs! He was also extremely friendly and helpful!

River Meadow

Zach, John and Omar have been simply amazing. We had a difficult fight getting our business off the ground and Security & Life helped us in every way they could. They’ve been outstanding in every way. They designed and installed dozens of cameras, ethernet ports and access control systems correctly the first time, they always answer immediately when we call and any issue we have is resolved almost immediately. We will never work with anyone else for security, fire or low voltage because you simply cannot improve on perfection.

Ruth Madrigal

I represent my company Superior Cabling Solutions, in some jobs I need to look for help from Zack my experience with him is great, he is a responsible, kind, punctual person and is an expert in his work. I recommend it 100 %.

Anto L

Zack was very nice and professional, he came as quickly as possible to resolve the issue with the doors and he was working in record time! I will definitely recommend him!

Donna Elliott

Security & Life integrations are the definition of reliability and professionalism. They communicate with precision, handle all challenges with expertise and consistently deliver results that exceed expectations.

Essa Faal

Great Experience from Start to Finish Zachary The installer arrived on time, completed the job efficiently, and made sure I understood how to use the system. The equipment is high quality, and the customer support has been great whenever I had questions. Couldn’t ask for better service.

Caya Stephens

Zach was absolutely amazing and had my system up and running in no time. It was a struggle trying to find a company that could assist me, from my initial phone call to Zach coming out this has been a great experience. I’m glad to have been able to find such a responsive company with a quick turn around. Zach I truly appreciate you and the knowledge you gave me. I’m good to go and back in business!

Stephen Faircloth

These folks do what they say they will do. I will recommend them to anyone needing the services they provide!!

Alexis Hasbrouck

Great service from Security & Life Integrations! They installed our fire and burglary alarms quickly and smoothly. Highly recommend!

Taylor Ridge

Zach and John have been amazing to work with getting switched over from ADT. Highly recommend and happy to be new customers!

Lucas Eckert

Amazing guys. John and zach are great guys and made the job seem easy. Never a mistake to choose these guys for the work.

bbrsales

SLI has been our go to fire alarm provider for years. We are very happy with their service and they even keep up with our fire alarm inspections to ensure we are in compliance. Highly Recommended…

Sparky FXSTI

Security & Life Integrations has been my preferred trusted partner of choice for all of my security needs. From the front office to the installation techs, the engaged team is very refreshing to work with for all of our needs from an industrial, warehouse, office standpoint.

Kyle Renner

Security & Life Integrations took over an existing security camera system we had onsite and I am extremely happy with the quality of the work!

Reilly Williams

Super happy with the quality of our security alarm system and cameras that they installed at both my home and business. I highly recommend. Their professionalism and service is unmatched.

Sam Maxwell

Great company to work with! I am very happy with the security cameras that they installed at our property. They are very quick to help pull footage and provide service when needed.