Security & Life Integrations Inc

Commercial Carbon Monoxide Detection

Carbon monoxide is the life safety hazard that does not announce itself. No smoke, no smell, no alarm unless something was installed to sound one. Commercial codes in North Carolina, South Carolina, and Georgia now require CO detection in a growing list of occupancies, and the detectors that satisfy an inspector are not the ones sold at a hardware store. We design, install, connect, and monitor carbon monoxide detection as part of the fire alarm system, for buildings from Raleigh to Atlanta.

Get a CO Detection Quote

Where Code Requires CO Detection in a Commercial Building

The requirement comes from Section 915 of the International Fire Code, which the state fire codes in NC, SC, and GA adopt with local amendments. In broad terms it applies to buildings in Group E (schools), Group I (care facilities and hospitals), and Group R (hotels, apartments, dormitories) that contain a fuel-burning appliance or fireplace, or that have an attached private garage. The detection goes in the rooms that contain the appliance, in sleeping rooms served by it, and on each level with an attached garage.

Local fire marshals interpret the edges differently, and renovations trigger the requirement in buildings that were grandfathered. The practical answer is to ask before the inspection rather than after. Our fire marshal inspection guide and the state-by-state inspection requirements post cover how the three states differ.

  • Hotels and Motels: Guest rooms and corridors served by gas water heaters, boilers, or pool heaters, plus any room with a fireplace.

  • Apartments and Dormitories: Units with gas appliances, units adjacent to boiler rooms, and buildings with enclosed parking under residential floors.

  • Schools and Childcare: Classrooms and offices served by gas-fired HVAC or kitchen equipment.

  • Assisted Living and Medical: Care facilities where occupants cannot self-evacuate and where detection must report to staff and the monitoring center.

Standalone Detectors vs System-Connected Detection

A plug-in CO alarm protects the room it sits in and tells nobody else. In a commercial building that is rarely enough. System-connected CO detection ties addressable detectors into the fire alarm control panel, so an activation identifies the exact device, sounds the right notification in the right zone, and transmits to the monitoring center as a supervisory or alarm signal depending on how the AHJ wants it handled. The detectors are supervised, so a failed sensor reports as a trouble instead of silently aging out.

NFPA 72 now carries the CO detection requirements that used to live in NFPA 720, which means the same inspection, testing, and documentation schedule as the rest of the fire alarm applies. For buildings with an existing addressable panel, adding CO is usually a matter of detectors, a loop extension, and programming. For buildings on a conventional panel or with no fire alarm at all, we lay out the options honestly, including listed 120-volt interconnected units where code allows them.

Parking Garages and Loading Docks

Enclosed parking structures and indoor loading docks have their own requirement, driven by the mechanical code rather than the fire code: CO sensors that control the ventilation fans, so the fans run when exhaust builds up and stay off when it does not. The sensors are different from life safety detectors, the setpoints are different, and the wiring goes to the building automation or fan controls. We install both kinds and keep them separate so a garage ventilation sensor never gets mistaken for a life safety device on an inspection.

Garages under apartments and hotels are where the two requirements meet. Detection in the residential floors above the garage is a life safety requirement; ventilation control in the garage is a mechanical one. Both end up on the same drawings.

Installation, Testing, and Monitoring

Detector placement follows the manufacturer's listing and NFPA 72: on the wall or ceiling in the appliance room, outside sleeping areas, and away from the dead air near corners and supply registers. Sensors have a listed life, typically five to ten years, after which the detector reports end-of-life and must be replaced. We log the install date on every device so the replacement lands on the inspection calendar instead of on an inspector's report.

Acceptance testing is witnessed by the AHJ on new installs. After that, CO detectors are tested on the same annual fire alarm inspection as the smoke detectors, with functional gas testing, not just a button push. Buildings on our fire alarm maintenance program get the sensor replacements scheduled automatically. Monitoring specifics for the two largest markets are on the Raleigh fire alarm monitoring and Charlotte fire alarm monitoring pages.

Carbon Monoxide Detector Installation in Raleigh, Charlotte, and the Triad

Most of our CO detection work comes from three situations: a hotel or apartment renovation in Raleigh or Charlotte where the plan review flagged Section 915, a school or childcare center in the Triad adding gas kitchen equipment, and an assisted living operator who wants detection reporting to the nurse station as well as the panel. Wake County, Mecklenburg County, and the City of Raleigh fire marshals each have their own submittal expectations, and we handle the permit and acceptance test as part of the job. City-level fire alarm pages for Raleigh and Charlotte cover the local process. Outside the Triangle and the Piedmont, we cover Columbia, Atlanta, and the rest of the service area.

Raleigh and Wake County permit paths, costs and the buildings the rule reaches are on carbon monoxide detector installation in Raleigh.

What Commercial CO Detection Costs

Adding addressable CO detectors to an existing fire alarm panel typically runs $250 to $450 per detector installed, including programming and the acceptance test, with a project minimum of around $1,500 for permit and testing time. Combination smoke and CO detectors, where the layout allows them, run $300 to $500 each and save a device. Listed 120-volt interconnected CO alarms, where code accepts them, are $120 to $200 each installed. Garage ventilation sensor systems are priced per sensor and per fan zone. These are typical figures; the quote follows the site walk and the AHJ conversation.

Monitoring of CO signals is included in standard fire alarm monitoring at no added monthly cost on most accounts. What the monthly fee buys explains how signals are handled.

Carbon Monoxide Detection Questions

Does my building need CO detection if it is all-electric?

Usually not under Section 915, unless it has an attached or enclosed garage or a fireplace. Some local amendments and some insurers go further. We confirm against the adopted code for your jurisdiction during the site walk.

Can CO detectors go on our existing fire alarm panel?

If the panel is addressable and has loop capacity, yes, and that is the cleanest approach. Conventional panels can sometimes take a CO zone through a monitor module. We check the panel model and spare capacity before quoting.

How often do CO detectors need to be replaced?

Sensors have a listed life, typically five to ten years depending on the model, and the detector signals end-of-life when it arrives. We record install dates so replacements are planned, not discovered.

Will a CO activation evacuate the building like a fire alarm?

That depends on how the AHJ wants it programmed. Many jurisdictions treat CO as a distinct signal with its own notification pattern so occupants know to leave the affected area and staff know it is not a fire. We program it to the AHJ's direction and document it.

Do you install CO detectors in houses?

No. We work on commercial, institutional, and multi-family buildings only. See the commercial-only page.

Our Certifications & Associations

NC State Board of Examiners of Electrical Contractors seal

SP-FA/LV License #36697

NC Board of Examiners of Electrical Contractors

North Carolina Department of Public Safety logo

NC Alarm Business License

NC Alarm Systems Licensing Board

North Carolina Department of Public Safety logo

Registered Alarm Technicians

NC Alarm Systems Licensing Board

South Carolina Law Enforcement Division seal

SLED Alarm Contractor License

South Carolina Law Enforcement Division

South Carolina Department of Labor, Licensing and Regulation logo

Burglar Alarm Contractor

SC Dept. of Labor, Licensing & Regulation

South Carolina Department of Labor, Licensing and Regulation logo

Fire Alarm Contractor

SC Dept. of Labor, Licensing & Regulation

NICET logo

NICET Level III

Fire Alarm Systems

$2M General Liability

Fully Insured

Brivo logo

Brivo

Manufacturer Certified

ButterflyMX logo

ButterflyMX

Manufacturer Certified

Bosch logo

Bosch Security Systems

Manufacturer Certified

Loved by Thousands of Organizations

Kesha Coley

I knew when I called and had a conversation with Donna that they would be a good fit to do business with. Donna and Zach was very friendly and responsive. I was switching from a different company and im so glad that I did. Zach came and installed a new security system for my business and was able to switch over my fire panel to meet county standards to stay in compliance. Zach was also able to switch my camera system to monitor. The transition process was smooth. Thank yall for helping us out at Brighter Minds Academy 2

Gianna

Zach with Security & Life Integrations did an awesome job with helping our new clinic set up the cameras and key fobs! He was also extremely friendly and helpful!

River Meadow

Zach, John and Omar have been simply amazing. We had a difficult fight getting our business off the ground and Security & Life helped us in every way they could. They’ve been outstanding in every way. They designed and installed dozens of cameras, ethernet ports and access control systems correctly the first time, they always answer immediately when we call and any issue we have is resolved almost immediately. We will never work with anyone else for security, fire or low voltage because you simply cannot improve on perfection.

Ruth Madrigal

I represent my company Superior Cabling Solutions, in some jobs I need to look for help from Zack my experience with him is great, he is a responsible, kind, punctual person and is an expert in his work. I recommend it 100 %.

Anto L

Zack was very nice and professional, he came as quickly as possible to resolve the issue with the doors and he was working in record time! I will definitely recommend him!

Donna Elliott

Security & Life integrations are the definition of reliability and professionalism. They communicate with precision, handle all challenges with expertise and consistently deliver results that exceed expectations.

Essa Faal

Great Experience from Start to Finish Zachary The installer arrived on time, completed the job efficiently, and made sure I understood how to use the system. The equipment is high quality, and the customer support has been great whenever I had questions. Couldn’t ask for better service.

Caya Stephens

Zach was absolutely amazing and had my system up and running in no time. It was a struggle trying to find a company that could assist me, from my initial phone call to Zach coming out this has been a great experience. I’m glad to have been able to find such a responsive company with a quick turn around. Zach I truly appreciate you and the knowledge you gave me. I’m good to go and back in business!

Stephen Faircloth

These folks do what they say they will do. I will recommend them to anyone needing the services they provide!!

Alexis Hasbrouck

Great service from Security & Life Integrations! They installed our fire and burglary alarms quickly and smoothly. Highly recommend!

Taylor Ridge

Zach and John have been amazing to work with getting switched over from ADT. Highly recommend and happy to be new customers!

Lucas Eckert

Amazing guys. John and zach are great guys and made the job seem easy. Never a mistake to choose these guys for the work.

bbrsales

SLI has been our go to fire alarm provider for years. We are very happy with their service and they even keep up with our fire alarm inspections to ensure we are in compliance. Highly Recommended…

Sparky FXSTI

Security & Life Integrations has been my preferred trusted partner of choice for all of my security needs. From the front office to the installation techs, the engaged team is very refreshing to work with for all of our needs from an industrial, warehouse, office standpoint.

Kyle Renner

Security & Life Integrations took over an existing security camera system we had onsite and I am extremely happy with the quality of the work!

Reilly Williams

Super happy with the quality of our security alarm system and cameras that they installed at both my home and business. I highly recommend. Their professionalism and service is unmatched.

Sam Maxwell

Great company to work with! I am very happy with the security cameras that they installed at our property. They are very quick to help pull footage and provide service when needed.