Security & Life Integrations Inc

Taking Over an Apartment Building's Access Control From the Old Installer

Can a new integrator take over our access control system from the company that installed it? That is the question a Raleigh property manager asked us this fall about fifteen doors on a platform the original vendor had stopped supporting. The answer was yes, and it is yes for most apartment communities in the Carolinas and Georgia. What changes from building to building is how much carries over, what the old company has to hand back, and whether the property actually owns what is on the wall. This page walks through all three.

Ask About Your Building

Do You Own the System, or Does the Dealer?

Start here, because it decides everything else. If the property bought the hardware outright, it owns the readers, controllers, strikes and wiring, and any licensed integrator can service them. If the system was installed under a lease or a bundled monitoring contract, the hardware may belong to the vendor until the term ends, and the contract will say what happens at termination. The third case is the one that catches managers: the property owns the hardware but the software license, the admin credentials or the cloud account are in the installer's name. The doors are yours; the ability to add a resident is not.

Ask the old vendor for three things in writing: the ownership status of the equipment, the admin credentials to the software or cloud account, and the as-built drawings or at least a door schedule. A vendor that will not provide them is telling you something. Switching commercial security providers has the full request list and the notice-period math.

What Carries Over and What Does Not

Most of an apartment access control system is wire and door hardware, and both are vendor-neutral. The parts that may not carry over are the controllers and the software:

  • Wiring: almost always stays: Reader, lock and door-contact cable runs are the most expensive part of the original install and the least likely to need replacing.

  • Strikes, maglocks, door contacts: stay: Standard hardware that any controller can drive. We test each one during the survey.

  • Readers: usually stay: Open-protocol readers work with a new controller. Proprietary readers tied to one platform get swapped, typically $250 to $600 each.

  • Controllers: depends: Open-platform controllers can be re-licensed to new software. Closed ones are replaced, which is the main cost in a takeover.

  • Resident credentials: re-issue or migrate: Fobs on an open format can be re-enrolled. Proprietary fobs mean a re-issue, which is a leasing-office project for a week.

  • Gate and intercom: usually stay: Operators and most telephone-entry panels carry over; the relay wiring to the new controller is the work.

What a Takeover Costs for a 50 to 300 Unit Property

A takeover that keeps the wiring, strikes and readers and replaces only the controllers and software typically runs a third of a new install. For a garden community with eight to twelve controlled openings, the usual amenity doors, mail and package rooms, a clubhouse and a vehicle gate, that lands between $8,000 and $20,000. A mid-rise with thirty to sixty doors including unit-entry readers runs $25,000 to $60,000. If the readers are proprietary and have to go, add $250 to $600 per door. New installs, for comparison, run $1,500 to $3,500 per door, which is why the first question is always what can stay. The per-door breakdown is in what access control costs per door.

Monthly costs change too. If the old system billed a per-unit subscription, the replacement is priced per door or per panel, or carries no software fee at all on an on-site platform. Cloud vs. on-premises access control lays out that choice, and a service agreement at $15 to $25 per door per month covers the inspections, batteries and resident changes afterward.

How the Cutover Runs Without Locking Anyone Out

A survey first: every opening tested, the controller model and firmware identified, the credential format read, and the software access confirmed. From that we know what stays and what goes, and the quote follows. Then the cutover is done one door at a time. The new controller goes in beside the old one, the door's wiring moves over, the door is tested, and the next door follows. Residents keep using the same fob at doors that have not moved yet and the same fob at doors that have, when the format carries over. When it does not, the leasing office hands out new credentials over a week while both systems run. The gate and the main entrance are done last and early in the morning. Nobody is locked out, and the office knows the schedule a week ahead.

The fifteen-door Raleigh building from the top of this page had readers that carried over and controllers that did not. The cutover took two days. The longer conversation, about putting the whole property on a platform the next vendor cannot orphan, took longer and was worth having. Taking over a building's security system covers the same process for cameras and alarms.

Picking a Platform You Will Not Have to Leave Again

The reason a takeover is needed is usually that the last platform was closed: one installer, one software license, one phone number. The way to avoid repeating it is to choose open-protocol readers and a controller platform that more than one integrator in your market can service, and to hold the admin credentials and the software license in the property's name from day one. We put that in writing on every system we install. The apartment access control buying guide goes through the platform decision, cloud access control covers the hosted option, and access control for multi-tenant housing covers the full apartment scope from unit doors to amenity schedules.

There is one case where we tell a manager not to take over: a system that is working, under contract, with a vendor who answers the phone. A takeover is for orphaned, failing or overpriced systems, and it is not a sales exercise.

Repairs During the Decision

A building deciding whether to take over its system still has doors failing in the meantime. Hardware repairs do not need the old vendor's software, so a strike, reader or power supply can be fixed while the ownership question gets sorted; see access control repair and the brands we service. City-level repair pages for Raleigh and Charlotte have local pricing. Amenity doors on schedules, the pool that closes at ten, are covered on amenity access control, and old lobby panels on telephone entry. The broader system takeovers page covers cameras and alarms alongside access control.

Apartment Access Control Takeover Questions

Can a new company take over our access control if the original installer will not cooperate?

Yes. Hardware the property owns can be serviced by anyone. Without the admin credentials we re-license open-platform controllers or replace closed ones, and residents are re-issued credentials. It costs more than a cooperative handover, which is why we ask for the credentials first.

Do residents need new fobs?

Only if the old fobs are a proprietary format. Open-format fobs are re-enrolled on the new system. We read the format during the survey and tell you before quoting.

How long does a takeover take?

One to three days on site for a garden community, longer for a mid-rise with unit-entry readers. Doors are cut over one at a time and both systems run during the transition, so nobody is locked out.

Who owns the software after you take over?

The property. Admin credentials and the software license are in the owner's or management company's name, in writing, so the next transition, if there is one, is a handover rather than a takeover.

Can you take over the gate and intercom too?

Usually. Gate operators and most telephone-entry panels carry over; the controller relay is rewired. Panels that call landlines nobody has are upgraded at the same time. See telephone entry.

Our Certifications & Associations

NC State Board of Examiners of Electrical Contractors seal

SP-FA/LV License #36697

NC Board of Examiners of Electrical Contractors

North Carolina Department of Public Safety logo

NC Alarm Business License

NC Alarm Systems Licensing Board

North Carolina Department of Public Safety logo

Registered Alarm Technicians

NC Alarm Systems Licensing Board

South Carolina Law Enforcement Division seal

SLED Alarm Contractor License

South Carolina Law Enforcement Division

South Carolina Department of Labor, Licensing and Regulation logo

Burglar Alarm Contractor

SC Dept. of Labor, Licensing & Regulation

South Carolina Department of Labor, Licensing and Regulation logo

Fire Alarm Contractor

SC Dept. of Labor, Licensing & Regulation

NICET logo

NICET Level III

Fire Alarm Systems

$2M General Liability

Fully Insured

Brivo logo

Brivo

Manufacturer Certified

ButterflyMX logo

ButterflyMX

Manufacturer Certified

Bosch logo

Bosch Security Systems

Manufacturer Certified

Loved by Thousands of Organizations

Kesha Coley

I knew when I called and had a conversation with Donna that they would be a good fit to do business with. Donna and Zach was very friendly and responsive. I was switching from a different company and im so glad that I did. Zach came and installed a new security system for my business and was able to switch over my fire panel to meet county standards to stay in compliance. Zach was also able to switch my camera system to monitor. The transition process was smooth. Thank yall for helping us out at Brighter Minds Academy 2

Gianna

Zach with Security & Life Integrations did an awesome job with helping our new clinic set up the cameras and key fobs! He was also extremely friendly and helpful!

River Meadow

Zach, John and Omar have been simply amazing. We had a difficult fight getting our business off the ground and Security & Life helped us in every way they could. They’ve been outstanding in every way. They designed and installed dozens of cameras, ethernet ports and access control systems correctly the first time, they always answer immediately when we call and any issue we have is resolved almost immediately. We will never work with anyone else for security, fire or low voltage because you simply cannot improve on perfection.

Ruth Madrigal

I represent my company Superior Cabling Solutions, in some jobs I need to look for help from Zack my experience with him is great, he is a responsible, kind, punctual person and is an expert in his work. I recommend it 100 %.

Anto L

Zack was very nice and professional, he came as quickly as possible to resolve the issue with the doors and he was working in record time! I will definitely recommend him!

Donna Elliott

Security & Life integrations are the definition of reliability and professionalism. They communicate with precision, handle all challenges with expertise and consistently deliver results that exceed expectations.

Essa Faal

Great Experience from Start to Finish Zachary The installer arrived on time, completed the job efficiently, and made sure I understood how to use the system. The equipment is high quality, and the customer support has been great whenever I had questions. Couldn’t ask for better service.

Caya Stephens

Zach was absolutely amazing and had my system up and running in no time. It was a struggle trying to find a company that could assist me, from my initial phone call to Zach coming out this has been a great experience. I’m glad to have been able to find such a responsive company with a quick turn around. Zach I truly appreciate you and the knowledge you gave me. I’m good to go and back in business!

Stephen Faircloth

These folks do what they say they will do. I will recommend them to anyone needing the services they provide!!

Alexis Hasbrouck

Great service from Security & Life Integrations! They installed our fire and burglary alarms quickly and smoothly. Highly recommend!

Taylor Ridge

Zach and John have been amazing to work with getting switched over from ADT. Highly recommend and happy to be new customers!

Lucas Eckert

Amazing guys. John and zach are great guys and made the job seem easy. Never a mistake to choose these guys for the work.

bbrsales

SLI has been our go to fire alarm provider for years. We are very happy with their service and they even keep up with our fire alarm inspections to ensure we are in compliance. Highly Recommended…

Sparky FXSTI

Security & Life Integrations has been my preferred trusted partner of choice for all of my security needs. From the front office to the installation techs, the engaged team is very refreshing to work with for all of our needs from an industrial, warehouse, office standpoint.

Kyle Renner

Security & Life Integrations took over an existing security camera system we had onsite and I am extremely happy with the quality of the work!

Reilly Williams

Super happy with the quality of our security alarm system and cameras that they installed at both my home and business. I highly recommend. Their professionalism and service is unmatched.

Sam Maxwell

Great company to work with! I am very happy with the security cameras that they installed at our property. They are very quick to help pull footage and provide service when needed.